TPS54618RTER Switching Voltage Regulators 2.95-6Vin,6A,2MHz Sync Step Down SWIFT
♠ Product Description
Product Attribute | Attribute Value |
Manufacturer: | Texas Instruments |
Product Category: | Switching Voltage Regulators |
RoHS: | Details |
Mounting Style: | SMD/SMT |
Package/Case: | WQFN-16 |
Topology: | Buck |
Output Voltage: | 800 mV to 4.5 V |
Output Current: | 6 A |
Number of Outputs: | 1 Output |
Input Voltage, Min: | 2.95 V |
Input Voltage, Max: | 6 V |
Quiescent Current: | 515 uA |
Switching Frequency: | 500 kHz |
Minimum Operating Temperature: | - 40 C |
Maximum Operating Temperature: | + 150 C |
Series: | TPS54618 |
Packaging: | Reel |
Packaging: | Cut Tape |
Packaging: | MouseReel |
Brand: | Texas Instruments |
Development Kit: | TPS54618EVM-606 |
Input Voltage: | 2.95 V to 6 V |
Moisture Sensitive: | Yes |
Operating Supply Current: | 250 uA |
Product: | Voltage Regulators |
Product Type: | Switching Voltage Regulators |
Shutdown: | Shutdown |
Factory Pack Quantity: | 3000 |
Subcategory: | PMIC - Power Management ICs |
Supply Voltage - Min: | 2.95 V |
Tradename: | SWIFT |
Type: | Voltage Converter |
Unit Weight: | 40 mg |
♠ TPS54618 2.95-V to 6-V, 6-A, Synchronous Step-Down SWIFT™ Converter
The TPS54618 device is a full-featured 6-V, 6-A, synchronous step-down current-mode converter with two integrated MOSFETs.
The TPS54618 enables small designs by integrating the MOSFETs, implementing current-mode control to reduce external component count, reducing inductor size by enabling up to 2-MHz switching frequency, and minimizing the IC footprint with a small, 3-mm × 3-mm, thermally-enhanced WQFN package.
The TPS54618 provides accurate regulation for a variety of loads with an accurate ±1% voltage reference (VREF) over temperature.
Efficiency is maximized through the integrated 12-mΩ MOSFETs and 515-μA typical supply current. Using the enable pin, shutdown supply current is reduced to 5.5-µA by entering a shutdown mode.
Undervoltage lockout is internally set at 2.6 V, but can be increased by programming the threshold with a resistor network on the enable pin. The output-voltage start-up ramp is controlled by the slow-start pin. An open-drain power-good signal indicates the output is within 93% to 107% of its nominal voltage.
Frequency foldback and thermal shutdown protect the device during an overcurrent condition.
• Two 12-mΩ (typical) MOSFETs for high efficiency at 6-A loads
• 300-kHz to 2-MHz switching frequency
• 0.8-V ±1% Voltage reference over temperature (–40°C to +150°C)
• Synchronizes to external clock • Adjustable slow start and sequencing
• UV and OV power-good output
• –40°C to 150°C Operating Junction Temperature Range
• Thermally enhanced 3-mm × 3-mm, 16-pin WQFN package
• Pin-Compatible to TPS54418
• Create a custom design using the TPS54618 with the WEBENCH® Power Designer
• Low-voltage, high-density power systems
• Point-of-load regulation for high-performance DSPs, FPGAs, ASICs, and microprocessors
• Broadband, networking, and optical communications infrastructure